Have motor oil pressure before startup with the easy to install Insta-Lube motor pre lube kit.
With the Insta-Lube prelube system protecting your motor, filtered oil is stored in the accumulator ready to pressurize the system BEFORE the first revolution of the crankshaft.
As soon as the ignition key is turned on the low oil pressure light will go out and the engine oil pressure gauge will start to register oil pressure before the starter engages!
Thereby completely eliminating all of the wear due to dry bearing abrasion!
The Insta-Lube pre oiler will work for all auto engines, boat engines, car engines, truck engines, classic car engines, motor home engines, suv engines, marine motors, gasoline motors, diesel motors, and propane motors. marine grade hardware and fittings ideal for all boats, sail boats, power boats, marine engines and inboard engines.
The Insta-Lube Kit Installs In Three Easy Steps
The oil galley is a series of very small holes that connect the oil pump to the main bearings, crankshaft bearings, cam bearings and hydraulic valve lifters and it only takes a small amount of oil to pressurize the system.
The storage tank is connected to the engine oil gallery with a 3/8in. hydraulic hose where the pressure-sending unit enters the engine block.
When the engine is running the oil pump fills and pressurizes the tank while the digital controller insures that the highest pressure and volume of oil is stored ready for the next start-up.
The next time you turn the key on oil is instantly returned to the oil galley to pressurize it just as though the oil pump was running.
There are 4 Insta-Lube kit sizes, the A-kit with a 3.25 x 11 in. tank is efficient enough to work on all 4, 6 and V8 engines.
The B-Kit with a 4.5 x 10 in. tank stores a higher volume of oil and works well for engines that go for long periods between start-ups.
The E-Kit with a 4.5 x 16 in. tank and the D-Kit with a 4.5 x 26 in. tank are for the largest industrial engines, stationary engines and marine engines.
The Insta-Lube kit includes an aluminum storage tank, marine grade solenoid valve, solenoid valve controller, mounting brackets, hydraulic hose, hose fittings, pipe fittings, fuse taps and wiring.
Main Bearing and Rod Bearing Knocking Prevented!
That's right with the Insta-Lube kit installed, your Main Bearings, Rod Bearings and Turbocharger Bearings will be pressurized and separated and the Hydraulic Timing Chain Adjusters will stop rattling on startup.
And a heavier weight oil can be used which will result in higher oil pressure and less Bearing Noise.
Turbo charged engines will benefit with the Turbo Pre-Post-Lube Kit installed to pressurize the engine and turbocharger bearings before start-up and maintains oil pressure on the turbo bearings after shutdown to Prevent coking and bearing failure.
|
